Sensor Gateway not working

agdatacomagdatacom
edited July 2013 in InfraSensing Sensors
This is the scenario, I configured the sensor gateway and update the firmware, when I click update button the device asked for a reboot then upon observation the device is working well. When I transfer directly on my laptop I noticed that upon power on the sensor gateway the LED indicator lights, after a seconds the light disappear and can’t access the device. I already tried to hard reset the device and used a POE switch to power on the Sensor Gateway.

Comments

  • AdministratorAdministrator
    What is the serial number and what firmware have you updated it to?
  • agdatacomagdatacom
    The serial number of the device is SGW2012110106136.

    firmware 2.11
  • AdministratorAdministrator
    You can request a RMA by sending an email to sales@serverscheck.com and refer to this post.



    Kindly note that if the unit is not defective following a manufacturing defect but due to improper configuration, then the repair will be invoiced (including return shipment to you).
This discussion has been closed.