Power sensor issues,SNMP on SensorGateway

MatejMatej
edited June 2013 in InfraSensing Sensors
Hi,



- we have two power sensors that despite being connected to the adapter that HAS power, always report a power failure problem. We have tried to connect them to two different gateways and the problem is the same, we also tried to change the adapters that go from the sensor to the power source, also with no positive result.



- on one gateway we have problems with SNMP - it seems that after two minutes after rebooting the device, SNMP stops responding (no response on SNMP queries). SNMP Traps work correctly and on other the same configured devices everything works, but on this sensor it simply doesn't no matter what we try. We also upgraded the firmware to the latest 3.03 - it's the latest HW with no success.



We need to get those issues solved as soon as possible.



Thank you!

Comments

  • AdministratorAdministrator
    The latest firmware is not 3.03 but 3.06 - please check the firmware page at http://www.serverscheck.com/sensors/firmware.asp
  • MatejMatej
    Thank you for the information.



    The issue with SNMP "dying" after some time could be related to this old firmware on the device, but how about those two power sensors? We have tried them with different SensorGateways HW 4 and 5 that work normally, but didn't manage to get them working. They always report: "fail" for power.



    Thanks!
  • AdministratorAdministrator
    You need to make sure that the power adapter is plugged into the power sensor
  • MatejMatej
    I am sure that power adapter is plugged into both power sensors (we have multiple of them working correctly), but the issues remain even after trying different adapters and different SensorGateways as mentioned before.
  • AdministratorAdministrator
    What is the firmware you have installed?
  • MatejMatej
    Those Power Sensors do not work with the SensorGateway with Hardware ID 4 AND with the SensorGateway HW 5 with firmware 3.06. We have tried a number of SensorGateways and the power is reported as FAILURE all the time, also with different adapters.



    We must use them and since they were bought about 6 months ago would like to return them for a warranty-check. They were connected and suddenly stopped working after one power failure and now they report FAILURE all the time.



    Looking forward TO a quick response.



    Thanks!
  • AdministratorAdministrator
    You could do a factory reset and then a firmware update on the base unit and see if it fixes the issue.
  • MatejMatej
    Tried that with no success. It looks like those units have their status as Power Failure no matter what we do. Now we have 3 of them that stopped working this was all of a sudden without reason when connected to the SensorGateway.



    We have to solve it since we currently do not have a reliable power failure detection on 3 locations due to those failures.
  • AdministratorAdministrator
    The units can be inspected for warranty repair. If the units failed because of a manufacturing defect, then such repair will be covered by the warranty.



    If the defect is caused by electrical damage (surcharge, wrong power adapter, ...) then this is not covered by the warranty.


This discussion has been closed.